golmar 2PLUS Manuel D'installation page 54

DOOR PANEL INSTALLATION
D
oor panel modules assemby.
Insert the lower closing head (marked ABAJO) in the lower module and fix it by
screwing the module shafts.
Place the module holder between the lower module and the next module, but make
sure that the holder notches are inside the door panel. Fix the following module
screwing the shafts. Repeat this procedure in case the door panel has another
module (the maximum number of modules linked vertically is three).
Insert the upper closing head (marked ARRIBA) in the last module and fix it using the
supplied screws.
Pass the wiring through the hole made in the
embedding box. Fit, flush and level it. Then, once
it is placed, remove the protective labels from the
fixation holes of the door panel.
P
lace the embedding box.
53