Blaupunkt 5GB 62190 Prescriptions De Montage Et Mode D'emploi page 35

Cleaning and Maintenance
BURNERS
■ Remove the burner lids and Flame Spreaders by pulling them upwards and away
the top plate.
■ Soak them in hot water and a little detergent or washing up liqui.
■ After cleaning and washing them, wipe and dry them carefully. Make sure that the flame
holes are clean and completely dry.
■ Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
■ Gently wipe the ignition device and flame supervision device with a well wrung-out
and wipe dry with a clean cloth.
■ Before placing the burners back on the top plate, make sure that the injector is not
blocked.
■ Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown
burners as follows :
1. Place the flame spreader (4) on to the burner cup (5) so that the ignition device and the
flame supervision device extend through their respective holes in the flame spreader. The
flame spreader must click into place correctly.
2. Position the burner lid (1,2,3) onto the flame speader (4) so that the retaining pins fit into
their respective recesses.
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
- The locating pins must fit exactly into the notches.
35
from
cloth