Maintenance - Haussmann 5848001 Mode D'emploi

Figure 5
6. Remove the bearing center and drive the spur center
into the other end of the wood. Make sure the spurs
are in the saw cuts. Remove the spur center.
7. Make sure the centers and the hole in the spindle and
the tailstock quill are clean. Insert the spur center into
the headstock and the bearing center into the tailstock.
Tap them in lightly with a piece of wood. Do not drive
them in.
8. Place the wood between the centers and lock the tailstock.
9. Move the bearing center into the wood by turning the
hand wheel. Make sure that the bearing center and
spur center are "seated" into the wood in the holes
made in steps 5 and 6. Rotate the wood by hand while
turning the hand wheel.
10. Adjust the tool rest approximately 1/8" away from the
corners of the wood and 1/8" above the center line.
Note the angled position of the tool rest base. Lock the
tool rest base and the tool rest.
Figure 6
TOOL REST
WARNING
Make certain that unit is disconnected from power source
before attempting to service or remove any component.
CLEANING
• Keep machine and workshop clean. Do not allow
sawdust to accumulate on the tool. Keep centers clean.
Check inside belt guard to make sure that saw dust has
not accumulated.
• Be certain motor is kept clean and is frequently
vacuumed free of dust.
• Use soap and water to clean painted parts, rubber parts
and plastic guards.
1/8"
WOOD
1/8"

MAINTENANCE

11. Observe the speed chart. Move the V-belt on the
pulleys to the slowest speed. Rotate the wood by hand
to make sure that the corners do not strike the tool
rest.
SQUARE LENGTH
up to 1" 1 to 12"
1" to 3" 1 to 12"
Figure 7
INSTALLING THE PEN MANDREL
• Remove spur center (Key No. 11) from
spindle (Key No. 9).
• Thread shaft securely into tapered sleeve (A).
• Slide workpiece (B) and bushings onto the shaft. Use an
appropriate number of bushings (C) so that workpiece
will be held securely.
• Secure workpiece and busings using knurled nut (D).
• Insert the tapered sleeve of the mandrel firmly into the
spindle.
• Use bearing center (Key No. 27.3) to support shaft end
of the mandrel.
B
A
Figure 8
LUBRICATION
• The shielded ball bearings are permanently lubricated
and require no further lubrication.
TOOL REPAIRS
• lf power cord is worn, cut, or damaged in any way, have
it replaced immediately.
• Replace any damaged or missing parts. Use parts list to
order parts.
• Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician. For
further information on available services, please call the
Customer service line at 1-800-599-5916 ext.2.
20
ROUGH FINISH SAND
RPM RPM RPM
1350 2250 3500
2250 3500 3500
D
C