Safety Rules - Haussmann 5848001 Mode D'emploi

Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement and other masonry products.
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area and work with approved safety equipment. Always wear OSHA/NIOSH
approved, properly fitting face mask or respirator when using such tools.
WARNING
For your own safety, read all of the rules and precautions before operating tool.
WARNING
Always follow proper operating procedures as defined in this manual even if you are familiar with use of this or similar
tools. Remember that being careless for even a fraction of a second can result in severe personal injury.
PRODUCTION SPECIFICATIONS
Horsepower (Maximum Developed) . . . . . . . .1/3
Voltage . . . . . . . . . . . . . . . . . . . . . . . . .120 volts
Amperes . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0
Hertz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . Single
RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3450
TABLE OF CONTENTS

SAFETY RULES

13
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Parts Illustration and List . . . . . . . . . . . . . . . . 21
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Rotation (viewed from left side) . . . . . Clockwise
Spindle speed . . . . . . . . . . . 1350 to 3500 RPM
Spindle thread . . . . . . . . . . . . . . . . . . . M20x2.5
Spindle taper . . . . . . . . . . . . . . . . . . . . . . . #1 MT
Tallstock taper . . . . . . . . . . . . . . . . . . . . . #1 MT