Assembly - Ferm GRM1023 Traduction De La Notice Originale

circulating water within the machine will soon
rise to a critical point, which will cause damage
to the sealing rings inside the machine.
• Don't start and run the machine in a place
excessively cold so as to prevent the machine
from the freezing current.
• This machine has been designed for only using
cleaning water, do not use corrosive chemicals.
• Use cleaning agent supplied or recommend by
the manufacturer.
• High-pressure jets can be dangerous if subject
to misuse. The jet must not be directed at
persons, animals, live electrical equipment or
the machine itself. Pressure washers should
not be pointed at tire walls, as it may be
possible to damage them.
• Do not direct the jet against yourself or others
in order to clean clothes or footwear.
• Disconnect from the electrical power supply
before carrying out user maintenance.
• If the mains cable is damaged it must be
replaced by the manufacturer, or its service
agent or similarly qualified person to avoid a
hazard.
• Do not use the machine if a supply cord or
important parts are damaged, e.g. safety
devices, high pressure hoses, trigger gun.
• Be aware of the recoil caused by the water jet
when the machine is switched on.
• When the machine is moving and installing,
the machine must be in flat. When moving the
machine, pulling the handle to move it.
• Connect to the water supply. The machines are
not suitable for connection to portable water
mains. Connect the machine to the water
supply. (It can be a water container).
• Make sure the inlet water pressure keeps
between 0.01MPa and 1.2MPa.The inlet pipe
should at least 5 M long. Do not use the pipe if
the pipe is damaged. If you want connect this
machine to portable water mains, you must
install a backflow preventer in the water pipe
to prevent dirty water flow back to the drinking
water system. The backflow preventer shall
comply with EN 60335-2-79 ANNEX AA.
6

3. ASSEMBLY

The motor of this pressure washer will
NOT run. It will only operate when the
trigger is squeezed.
CAUTION! The cleaner must only be
used with clean water; use of unfiltered
water or corrosive chemicals will damage
the cleaner.
• Turn the motor switch to the "0" position.
• Check that the electrical supply voltage and
frequency (Volts/Hz) correspond to those
specified on the cleaner data plate.
• Ensure that you have a suitable water supply
to feed the pressure washer.
• Connect the outlet hose to the washer and
connect the spray gun to the outlet hose.
• Connect lance and possibly lance extension.
• Check gauze filter is clear of any blockage.
• Connect the water supply hose.
• Check that the hose has no kinks in it.
• Turn on water and check for leaks.
• Squeeze trigger to allow air to be expelled
though the pump and hoses, lock trigger.
• Plug in machine and turn on switch.
• Unlock trigger and use the pressure washer.
Shut down
1. Turn off the motor (turn switch to the off position).
2. Unplug the unit from the power source.
3. Turn off the water supply.
4. Press the trigger of the gun to depressurize the
system.
5. Disconnect the garden hose from the pressure
washer.
6. Wipe all surfaces of the unit with a damp clean
cloth.
7. Engage the gun safety lock.
CAUTION: ALWAYS turn off the unit's
motor BEFORE turning off the unit's water
supply. Serious damage could occur to
the motor if the unit is run without water.