LEXIBOOK RP500DC Mode D'emploi page 9

WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, press
the RESET button or remove the batteries and insert them again.
Installation
Unpacking the device
When unpacking, ensure that the following elements are included:
1 x Cars Radio Alarm Clock Projector
1 x instruction manual
WARNING: All packaging materials, such as tape, plastic sheets, wire ties and
tags are not part of this product and should be discarded.
Settings
CLOCK
1. To set the clock, press MODE 3 times.
2. Press SET once: the minute digit starts flashing.
3. Press ADJUST to change the setting value. Then press SET to move to the
next setting.
The setting sequence is displayed in the following order:
Minutes Hours Date Month Day of the week.
5. Press and hold ADJUST to quickly scroll through the values.
To view the date and alarm time:
In clock mode, press and hold ADJUST to check the date or press and hold SET
to check the alarm time.
ALARM
1. To set the alarm, press MODE twice.
2. Press ADJUST to change the hour value. Then press SET to move to the next
setting.
3. Press ADJUST to change the minute value. Then press MODE to confirm.
4. When the alarm sounds, press ADJUST to snooze the alarm for 5 minutes or
press SET to turn it off. The alarm will ring at the same time the next day.
To activate or deactivate the alarm:
In clock mode, press SET and ADJUST at the same time. appears when the
alarm is activated.
9
RP500DC_IM1091_2nd 1Mar11.indd 9 01/03/2011 4:10 PM