Cleaning; Clean Drive Unit; Clean Mixing Bowl; Troubleshooting - Exquisit MU 3002 we Manuel D'instructions

EN

14 Cleaning

WARNING
Improper handling of the blender can be
causing an electric shock. Water
penetrated in the housing can cause a
short circuit.
Turn the blender off, and remove the
power plug from the socket before
cleaning the blender. Make sure that no
water gets into the housing of the drive
unit.
Never immerse the blender in water.
Improper handling of the blender can lead
to damage. Do not place the blender or
individual parts in the dishwasher.
Do not use abrasive cleaners or scouring
agents, sharp or metallic cleaning objects
such as knives and the like. These can
damage the surface.

15 Troubleshooting

Error
The jug is not sitting correctly on the
drive unit.
The security cover does not sit correctly
on the mixing bowl.
The blender is
not functioning
The power cord is not properly
connected in the socket.
The socket has no electricity.
The speed control is not turned up far
enough.
The blades do A not suitable for mixing good is in the
not rotate. mixing bowl.
When in doubt, consult a qualified expert.
Seite | 18
Possible reason

14.1 Clean drive unit

1. Unplug the power plug before
cleaning.
2. Allow to cool the blender entirely.
3. Wipe the drive unit 7 with a dry,
possibly slightly damp cloth.
4. Rub the drive unit then dry. Use a soft
cloth for this.

14.2 Clean mixing bowl

The blades are very sharp. A touch of the
knife during cleaning can cause injury.
Use care and caution when cleaning and
drying the blender container and the
knife.
Do not touch the knife with bare hands.
1. Place the jug on the drive unit as
described in "Compose blender".
2. Pour some lukewarm water with
detergent into the mixing bowl.
3. Cover the mixing bowl with the safety
cover 2 and the lid insert 1 (see "Use
blender").
4.
Set the speed control 8 to level "0".
Set the speed control to level "0" and
unplug the power cord from the
socket.
Put the jug on the drive unit, as
described in "Compose blender".
Set the speed control to level "0" and
unplug the power cord from the
socket.
Place the safety lid on the blender jug,
as described in "Compose blender ".
Connect the power cord correctly to a
socket.
Check the socket by connecting
another device.
Turn the speed control clockwise until
the blender starts.
Set the speed control to level "0" and
unplug the power cord from the
socket. Empty the mixing bowl.
Solution