Zs Alloy Jammers; Zs Carbon Jammers - Spinlock XX Série Mode D'emploi

ZS Alloy Jammer
If fitting to the deck, install the jammers forward of the winch, close enough
for easy operation of the handle and latch, ensuring enough space is left
behind the product for removal of the jaw assembly for maintenance. The
jammers are provided with studs (A4-70 stainless steel) in a pattern. This
helps spread the load into lightweight composite decks or masts.
They are a tight fit to ensure good thread engagement. Drilling templates
for deck layout are provided with the product.
Warning : The studs should be screwed a maximum of 15mm into
the body. Over tightening may damage internal bearing surface
Side Mounting : Replace the six body fasteners with longer bolts. These
can be inserted from either side by removing the round insert nuts. These
must be at least A4-70 stainless steel bolts if the maximum safe working
loads are to be reached. Refer to specification chart (page 7).
Double check the hole pattern before drilling. The pattern is not
reversible.
Mast Mounting : Mast mounting plates are available, see page 34 for
details. CAD templates can be download from:
www.spinlock.co.uk/cadlibrary
The Jammers are not designed to withstand high side loads. If the lead
angle to the winch is greater than 10 degrees, fit lead blocks or organisers
aft of the jammers. Contact the Special Projects Team for details of our TS
High Load Aft Organiser.
16
www.spinlock.co.uk
ZS Carbon Jammer
If fitting to the deck, install the jammers forward of the winch, close
enough for easy operation of the handle and latch, ensuring enough
space is left behind the product for removal of the jaw assembly for
maintenance. The jammers are provided with studs (A4-70 stainless
steel) in a staggered pattern. This helps spread the load into lightweight
composite decks or masts.
Warning : The studs should be screwed a maximum of 15mm into
the body. Over tightening may damage internal bearing surface.
They are a tight fit to ensure good thread engagement. Drilling templates
for deck layout are provided with this product.
Side mounting : ZS1014B and ZS1618B Carbon Jammers are designed
to be side bonded.
Mast Mounting : Mast mounting plates are available, see page 34 for
details. CAD templates can be download from:
www.spinlock.co.uk/cadlibrary
Bonded Mounting : ZS1014B and ZS1618B are designed for bonding
directly onto decks, spars and booms.
Note: we are unable to provide engineering data on materials and
instructions for bonding. You must refer to your own engineering design
data, load data and materials supplier for guidance.
The Jammers are not designed to withstand high side loads. If the lead
angle to the winch is greater than 10 degrees, fit lead blocks or organisers
aft of the jammers. Contact the Special Projects Team for details of our TS
High Load Aft Organiser.
how to use
ZS Alloy / Carbon
pages 8-9
maintenance spares
17
pages 22-23 pages 34-35