Important; Parts List; Date Of Manufacture - Evenflo Secure Step Gate Mode D'emploi

To prevent serious injury or death, securely install gate and use according to manufacturer's
instructions and warnings.
• NEVER use with a child able to climb over, dislodge, or open the gate.
• NEVER leave child unattended.
• NEVER use to keep child away from pool.
• Intended for use with ONLY with children 6 months through 24 months.
• To ensure proper fit, use ONLY on openings between 29 inches (74 cm) and 42 inches (107 cm) wide.
• To prevent entrapment, DO NOT allow space between bottom of gate and floor to exceed 3 inches (7.62 cm).
• Gate MUST ALWAYS swing away from stairs.
• ALWAYS keep gate securely locked in a closed position. Remove gate from opening when not in use.
• Use ONLY with locking mechanism securely engaged.
• To prevent falls, DO NOT step over gate.
• STOP using gate if any parts are missing or become damaged.
• Periodically check all fasteners to be sure they are tight and secure.
• This gate will NOT necessarily prevent all accidents.
• For indoor use ONLY.
• When installing against drywall, make sure mounting surface is reinforced with a wall stud.
• STRANGULATION HAZARD – Pets can force themselves into very small openings. Use this gate only with pets whose head or body
WILL NOT fit into openings in the gate, between the gate and the floor, or between the gate and the wall
• Ensure child is kept away from the gate when closing or opening it to prevent injury to the child, such as from pinching.
Important Information
IMPORTANT: Failure to follow installation instructions could result in serious injury to your child. Read these instructions completely
and keep for future reference.
The gate MUST be mounted with the screws and hardware provided.

Parts List

If you are missing parts, visit us at www.evenflo.com or call ParentLink at 1-800-233-5921.
#10 x 3" Pan head screw (4)
Hex Key (1)
Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal
information. To register your product, please complete and mail the card that came with it or visit our online registration at:
www.evenflo.com/registerproduct.
For future reference, record the Model Number and Date of Manufacture below.
Model Number:
•
www.evenflo.com • USA: 1-800-233-5921, 8 AM – 5 PM EST
• Canada: 1-937-773-3971 • México: 01-800-706-12-00
WARNING!
.
Gate (1)
Latch Bar (1)

Date of Manufacture:

Measuring tape, electric drill with 9/64" (3.5 mm) drill bit, Phillips screwdriver, and eye protection.
Use ONLY a handheld Phillips screwdriver when installing screws.
Decide where you want to install the gate and go through the following checklist:
The opening must be between 29 and 42 inches (74 and 107 cm).
Is the gate at the top or bottom of the stairs?
Use at the top or bottom of stairs ONLY if:
• The gate is mounted so that it is positioned over the floor at the top or bottom of the stairwell.
• The stairwell allows for gate to be mounted LESS than 3 inches (7.62 cm) above the floor.
WARNING!
DO NOT use on stairs if the gate is in a location over the open area above a step.
The hardware on both sides of the gate must be mounted in solid wood, such as a door jamb, solid wood banister
post, or wall stud behind drywall.
WARNING!
DO NOT use if one or both sides of the opening requires mounting in sheet rock, plaster, lath
board, or any wall without solid stud support to screw into.
Are there baseboards?
The gate wall brackets must be mounted to a flat surface. If your baseboard moldings have uneven surfaces where the wall
brackets need to be mounted, you need to choose another location. Try moving the wall brackets to a different spot on the
molding or above the baseboard molding.
WARNING!
DO NOT mount on uneven molding or woodwork trim.
Hinge bar must be flat against wall. Bottom of hinge bar can be NO MORE than 1 inch (2.5 cm) from floor.
WARNING!
The gate MUST be no more than
3 inches (7.62 cm) above the floor.
Tools Required
Before You Begin
1