Specifications - Sony BRAVIA KD-75S9005B Guide De Référence

The illumination LED is turned on.

If you do not wish to illuminate the centre and
side illumination LED, you can turn it off later.
Press HOME, then select
[System Settings] t [General Set-up] t
[Illumination LED] t [Off].
To turn off the side illumination LED only, press
HOME, then select
Settings] t [General Set-up] t [Illumination LED]
t [Side Illumination LED Off].
You can also press OPTIONS to get [Illumination
LED] setting.
Cannot connect to a wireless router by WPS.

If you use WEP security, select [Easy] t [Wi-Fi] t
[Connect by scan list]. Then, select the network
name (SSID) you want to connect.
Cannot find the required network name in
network setup.

Select [[Manual Entry]] and press
network name.
[Settings] t
[Settings] t [System
to enter

Specifications

System
Panel system
LCD (Liquid Crystal Display) Panel, LED Backlight
TV system
Analogue: Depending on your country/area
selection: B/G, D/K, L, I, M
Digital: DVB-T/DVB-C
DVB-T2
Satellite: DVB-S/DVB-S2
Colour/video system
Analogue: PAL, SECAM, NTSC3.58, NTSC4.43
Digital: Refer to the i-Manual.
Channel coverage
Analogue: UHF/VHF/Cable, Depending on your
country/area selection.
Digital: UHF/VHF/Cable, Depending on your
country/area selection.
Satellite: IF Frequency 950-2150 MHz
Sound output
10 W + 10 W + 10 W + 10 W + 10 W + 10 W
Wireless technology
Protocol IEEE802.11a/b/g/n
Input/Output jacks
Antenna (aerial) cable
75 ohm external terminal for VHF/UHF
Satellite antenna MAIN/SUB
Female F-Type Connector IEC169-24, 75 ohm.
DiSEqC 1.0, LNB 13 V/18 V & 22 kHz tone, Single
Cable Distribution EN50494.
/ AV1
21-pin scart connector (CENELEC standard)
including audio/video input, RGB input and TV
audio/video output.
/ COMPONENT IN
YP P (Component Video): 1080p (50, 60 Hz),
B R
1080i (50, 60 Hz), 720p (50, 60 Hz), 576p, 576i,
480p, 480i
Audio input (phono jacks)
AV2
t
Video input (common phono pin with Y input)
GB
15 GB