Maintenance; Troubleshooting - Biesemeyer T-square Manuel D'utilisation

CAMFOOT PLACEMENT
When clamping the fence assembly (YY) Fig. 28 to the
guide tube (C1), make certain the camfoot (D1) is hanging
down and in between the locking handle (RR) and the
guide tube (C1) — not caught on top of the guide tube.
A properly clamped fence assembly is shown in Fig. 29.
FENCE OPERATION
To move the fence along the guide tube, simply lift up the
locking handle (RR) Fig. 29, as shown, slide the fence to
the desired position on the guide, and push down locking
handle (RR) Fig. 28 as shown, to lock in position.
NOTE: A magnet (E1) Fig. 29, is provided to hold the
handle in the up position (as shown in Fig. 28) when
moving the fence.
FINAL FENCE CALIBRATION
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
The distance the fence is positioned away from the
saw blade is indicated by the witness line (F1) Fig. 30
located in the cursor. To calibrate the cursor to the saw
blade, make a test cut with the fence locked in position.
measure the width of the cut piece. Adjust the cursor by
loosening screws (G1). Move the cursor until the witness
line is aligned with the same marking on the scale as
the cut piece. Tighten the two screws (G1). Repeat until
the width of the cut piece matches the measurement
indicated by the witness line.

MAINTENANCE

To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
Apply grease to locking handle at (H1) and camfoot (D1)
Fig. 31, monthly to prevent wear.
Apply paste wax to the fence sides and the guide tube
sliding surfaces weekly. meguiar's Professional Paste
Wax (M-2611) is recommended. Also, saw table and
extension table surface should be waxed.
For assistance with your machine, visit our website at www.deltaportercable.com/biesemeyer for a list of service
centers or call the BIesemeyer

TROUBLESHOOTING

help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
®
YY
C1
13
RR
D1
FIG. 28
E1
FIG. 29
G1
F1
FIG. 30
H1
D1
FIG. 31
RR