Grill & Fan Blade Assembly - Beko EFS7700W Manuel D'utilisation

4 Grill & Fan blade assembly
1. Put the rear guard on the adjustable head by inserting three holes on the rear guard to the three
pins on the head. Firmly tighten the rear guard fixing nut by turning it clockwise.
2. Insert the big blade on the motor shaft with putting the attention of its correct position. The two
pins on the motor shaft should match with two holes on the big blade holder.
3. Hold the big blade and firmly tighten the small blade to the motor shaft by turning it anticlockwise.
4. Put the front guard on the rear guard. Make sure that each guide on the front guard is locked in the
outer ring of the rear guard.
5. Close the plastic lock on the front blade. Firmly tighten the screw by turning it clockwise.
8 / 72 EN
5
3
2
4
Fig. 4
1
2
Fig. 3
1
Stand fan / User Manual