Custom Settings - Fellowes Cambio Mode D'emploi

6. RESET THE CONTROL UNIT
release the buttons until the process is complete.
7. TROUBLESHOOTING
Error No. Description
Electrical problem
E02 Screw rod error
E04 Digital controller connection error
Collision avoidance system
E06 Electrical problem
E08 Desktop inclines
E11 No connection
Abnormal current
E13 Motor wire broken
E14 Hall wire broken
Short circuit
Note:
reset and return to normal operation after approximately 20 minutes.
the current height displayed.

CUSTOM SETTINGS

For all of the below Custom Settings:
and
Custom Setting 1: Minimum & Maximum Height Settings
Note: Default minimum height is 62cm (24.4") and the adjustable range is 62-118cm (24.4"-46.4"). Default maximum height is 128cm (50.4") and the
adjustable range is 72-128cm (28.3"-50.4").
8
Solution Error No.
Disconnect power for
30 seconds and reconnect
Reset the system
Check the connection
then reconnect the power
Release the button E21
Replace the control box E23
Reset the system E24
Replace the control box
Check then replace the motor cord
E42
Check then replace the motor cord
E43
at any time.
once and then press
Description
Motor failure
Desk run in wrong direction
Weight overload
No connection
Motor wire broken
Hall wire broken
Short circuit
Desk run in wrong direction
Memory function failure
Sensor Failure of Collision
Avoidance System
or to set desired minimum height. Press
once and then press or to set desired maximum height. Press
Solution
Reset the system
Remove the items on the desktop
Replace the control box
Replace the control box
to save: