Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
drill holes in the wall for the fasteners. The narrow end of the keyhole slot should face up.
5. Make electrical connections.
ELECTRICAL CONNECTIONS:
a.
Connect the white wire(s) from the fixture to the white wire of the supply circuit.
b. Connect the black wire(s) from the fixture to the black wire of the supply circuit.
c.
Connect the green colored (or bare copper) wire to the grounding conductor of the
supply circuit.
d. Use U.L. Listed wire connectors suitable for the size, type and number of conductors.
No loose strands or loose wires should be present.
e.
Secure wire connectors with U.L. Listed electrical tape.
f.
Carefully tuck connected wires back into the outlet box.
FINAL ASSEMBLY:
1. Spread the electrical splices so that the black wires are on one side of the outlet box
and the white wires are on the other side.
2. Place the front cover (B) against the back mounting plate (A). Push each socket cup
(C) onto socket firmly against cover (B).
3. Install light bulbs (D) (sold separately).
CAUTION: Refer to the re-lamping label located near the lamp holder for recommended
maximum wattage. DO NOT exceed the recommended maximum wattage.
4. Restore electricity and check the operation of your new lighting fixture.
ASSEMBLY AND INSTALLATION DIAGRAM:
CLOCKWISE
GREEN OR BARE (GROUND)
WHITE (NEUTRAL)
BLACK
(HOT)
3
Publicité
Table des Matières
