Romus CT 200 Mode D'emploi page 13

After mounting the appropriate tools the operation of the planet can begin.
Lower the planer with the lever to the operating position. Turn the hand wheel of the height
adjustment until the tools are lowered to the floor and until you achieve the required finish.
Attention: Lowering the tools too much decreases the performance of the machine. You will
also destroy the shafts in the drum and the bearings of the machine.
Attention: Never switch the motor of the planer on while the tools still touch the floor. Always
lift the machine and the tools clear from the floor and then switch the motor on.
Heavy dust can be avoided by connecting a dust collector to the dust port.
 Do not use the machine in a poorly ventilated area.
 Carbon monoxide is invisible, odorless and it can be deadly.
Attention: Before any maintenance, the machine must be brought to a complete
stand still. Always disconnect the machine if it is an electric model
 Lift the machine with the lever so that the tools are well clear of the floor.
 Unscrew the screws on the right side plate (M10, Key width 17 mm).
 Carefully remove the side plate.
 Take out the drum. Remove worn out tools. Check shafts and drums for wear and tear. If
necessary replace new tools on the drum.
 Push drum on freshly greased shaft.
 Reconnect side plate.
 Ajusting the drum: During the operation of the CT 200 floor planer or after a drum has
been changed or replaced, the drum shaft and the rear wheel axis can fall out of
alignment. This results in an uneven track on the floor. On one side the drum touches the
floor before the other and therefore removes more surface material on this side.
Raboteuse de sol – CT200 | Rèf. 94512
OPERATING
TOXIC EXHAUST
Changing the drum
13