Connecting Peripheral Equipment; Video Recorder; Other Equipment; Amplifier - Philips 15PT6807/01 Mode D'emploi

Connecting peripheral equipment

Video recorder

Other equipment

Amplifier

Side connections

4 5 6
7 8 9
Á
0
Ø
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the only
connection possible is via the aerial cable.You will therefore need to
tune in your video recorder's test signal and assign it programme
number 0 (refer to manual store, p. 5).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket of
the video recorder.You will then be able to record scrambled
transmissions.
Satellite receiver, decoder, games, etc.
Make the connections as shown opposite.
To connect a Hi-fi unit, use an audio connecting table and
connect :
- the "L" and"R" outputs of the TV set to an "AUDIO IN" "L"
and "R" of the Hi-fi unit.
- The "PCM" output of the TV set to a "DIG IN" input of the
amplifier (amplifier with digital coaxial input).
Make the connections as shown opposite.
Headphones
When headphones are connected, the sound on the TV set
will be cut.The
level.
The headphone impedance must be between 32 and 600 Ohms.

To select connected equipment

n
Press the key to select EXT and AV for the side connections.
Most equipment (decoder, video recorder) carries out the switching itself.
@"#
keys are used to adjust the volume
0
.
13