Maintenance; Use - WOLFF Junio-Stripper Mode D'emploi

3.4 Genuine Spare parts
Spare parts and accessories are manufactured uniquely for the
JUNIO-STRIPPER. It must be emphasized that parts obtained
from unauthorized sources must not be used.
WOLFF cannot be held responsible for the performance of or
any damage arising from the use of machines in which genuine
spare parts have not been used.
This is particularly important with replacement blades.

4.0 Maintenance

The JUNIO-STRIPPER is maintenance-free.
4.1 Changing the blade
Disconnect the power supply before changing the blade. Use
work gloves for your own safety.
put on the blade protection (enclosed in the tools set)
clean and loosen the screws of the blade mounting,
set the wrench at a position opposite to the blade to avoid
injury.
replace the blade.
Make sure that the blade fits in exactly into the support. On normal
and hard subfloors the bevel of the blade should show upwards
(1), on soft subfloors (e.g. chipboards) the bevel should show
downwards (2).
4.2 Replacing the carbon brushes
The motor is equipped with carbon brushes with an automatic
switch off as soon as the carbon brushes get abrased. This
avoids damages at the collector.
If the carbon brushes get replaced at a residual length of 7,5
you can obviate the machine from switchin off automatically.
Both carbon brushes have to be replaced at the same time.
Replacement of the carbon brushes:
Screw off hood (Pos. 69, see annexe)
replace carbon brushes (Pos 67)
atach hood again
Item no. carbon brushes: 230 V, 018337, 120 V, 019487

5.0 Use

5.1 Assembly
For your safety the JUNIO-STRIPPER comes with the blade not
mounted. It is fitted directly at the buttom of the striker
5.2 Switch-on/off
Switch-on
: Start the machine by pushing switch A forward.
The switch aressts automatically. The machine keeps running
08/2006 JUNIO-STRIPPER 07, Artikel-Nr. 016876
Wolff cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
to take care of all directions from the operating
manual and
the execution of maintenance and service.
Very sharp blade! You may cause injury without using
the blade protection!
1
mm,
2
9 9