Vollrath 59500 Mode D'emploi page 3

NOTE:
Exposed wood or particle board edges must be sealed with an
appropriate waterproofing material. Seal the edge between the
glass and the countertop with silicone or similar material. Failure to
do so may result in damage to the countertop.
E
D
Unit Cutout Dimensions for Drop-in Models
Dimension Size
A
14-11/16" (37.0 cm)
B
13-3/8" (34.0 cm)
C
11-3/4" (30.0 cm)
D
12-11/16 (32.0 cm)
"
E
1/4 (.63 cm)
F
Countertop
c b
ontRol ox
1. Measure the area for the control box cutout.
IMPORTANT: There must be 4" (10 cm) behind the control
box and any surrounding surface.
A
B
C
D
Control Box Cutout Dimensions for Drop-in Models
Dimension Size
A
6½" (16.5 cm)
B
⅞
4 " (12.4 cm)
C
5" (12.7 cm)
D
4" (10 cm)
E
3-1/16" (7.8 cm)
F
⅝
2 " (6.7 cm)
G
2-11/16" (6.6 cm)
F
A
B
C
E
F
G
2. Seal the joint between the induction warmer and countertop.
3. Plug the power cord into a grounded electrical outlet with the matching
nameplate rated voltage.
NOTE:
Using a voltage other than the nameplate rated voltage will cause
damage to the unit. Incorrect voltage, modification to the power
cord or electrical components can damage unit and will void the
warranty. Induction units are to use a separate dedicated circuit.
o
Peration
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
If liquid spills or boils over onto the unit, immediately unplug the unit
and remove cookware. Wipe up any liquid with a padded cloth.
1. Place the induction-ready cookware containing food in the center position
of a heating surface.
NOTE:
Do not pre-heat empty cookware. Because of the speed and
efficiency of the induction range, cookware can very quickly
overheat and be damaged.
NOTE:
Do not drop cooking utensils or other objects onto the cooking
surface. The strong, non-porous surface can break. The warranty
does not cover this type of abuse.
2. Press the ON/OFF button. The DISPLAY panel will show a power level
or the HEAT DISPLAY LED will light. When an induction ready cookware
pan is placed on the heating surface, the DISPLAY panel will remain on,
or the HEATING LED will illuminate. This indicates the unit is heating.
Burn Hazard.
Do not touch cookware, heating surface, food, or
liquid while heating.
Hot food and liquids can burn skin. Induction heating surfaces heat
very rapidly. Use caution when adding pre-heated oil, liquid or other
food already in the cookware.
Units with DISPLAY panels are equipped with an "over-heating protection"
feature. If the temperature of the cooking surface becomes too hot, the unit
will turn off. The display will flash "F2" to indicate the unit is in "over-heating
protection" mode. After the unit has cooled, turn the cooking surface on and if
"F2" is not displayed, then cooking can resume.
The display window should remain constant during operation. If the display is
flashing, see the TROUBLESHOOTING section in this manual.
Removing cookware from the cooking surface for more than five minutes will
cause the unit to automatically turn off. Removing cookware for less than five
minutes will not interrupt operation of the unit.
All units will start in Power Mode when turned on first time.
WARNING
WARNING
O ' M
peratOr s anual
3