Cleaning And Maintenance - Bestron ASM250Z Mode D'emploi

Masquer les pouces Voir aussi pour ASM250Z:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 5
OPERATION
The appliance is intended only for domestic use, not for professional use.
The following description is associated with the image on page 2:
1. Power button
2. Turbo button
3. Motor housing
4. Rod
5. Knives
6. Cord and plug
1. Take the appliance out of the packaging.
2. Clean the appliance (see 'Cleaning and maintenance').
The stickmixer is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for
mixing drinks and milkshakes. The stickmixer is equipped with two finger-tip pressure switches. Switch I to
blend at a low speed, pressure switch II to blend at a high speed.
3. Install the rod to the motor housing by turning it counterclockwise until it clicks.
4. Put the ingredients to be mixed in a bowl. Make up with a small amount of moist substance such as milk,
juice, water to make mixing easier.
5. Potatoes and vegetables can be pureed in the saucepan, but the saucepan must first be removed from
the heat source.
6. Next, insert the plug into the plug socket.
7. Hold the Hand Blender upright in the bowl or pan. Then switch on the device by pressing the on / off
button. Once the button is released, the unit will stop mixing.
8. If mixing at high speed is required, hold down the turbo button. Once the button is released, the unit will
stop mixing.
9. Hold the bowl / pan during use so that it cannot slide off the worktop.
10. Switch off the appliance after use by releasing the switch. Once you have finished, remove the plug from
the plug socket.
WARNING:
Never turn on the mixer if the mixing stick is not in the bowl/saucepan. Otherwise, the sharp knife may
cause serious injury.
The mixer may not be used for more than one minute without stopping. After that let the appliance cool
down to room temperature.

CLEANING AND MAINTENANCE

1. Remove the plug from the wall socket and allow the appliance to cool down sufficiently.
2. Remove the rod from the motor housing by turning it clockwise.
3. Put the hand blender in a cup half filled with warm water. Hold the cup firmly and turn on
the device for a few seconds. The knives have now been cleaned.
4. The stickmixer can be cleaned by rinsing it with running tap water. Dry it thoroughly.
5. Clean the appliance's motorunit with a damp cloth. After cleaning, dry the unit thoroughly.
6. Store the appliance.
WARNING:
Be careful with the sharp knife during cleaning.
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
SERVICE
If an unexpected problem occurs, please visit www.bestron.com/service for assistance.
10
EN

Publicité

Table des Matières
loading

Table des Matières