Electrical Safety; Additional Safety Instructions For Batteries And Chargers - Black & Decker MFL143 Mode D'emploi

When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.

Electrical safety

Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
p
u
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the bat-
u
tery in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
(Original instructions)
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Head release button
4. Bit holder
5. Battery
6. Battery release buttons
7. Drill/screwdriver head
8. Torque adjustment collar
9. Chuck
Fig. A
10. Jigsaw head
11. Blade clamp
12. Saw shoe
13. Sander head
14. Sanding base
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (fig. B)
To fit the battery (5), line it up with the receptacle on the
u
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (6) while at
u
the same time pulling the battery out of the receptacle.
Fitting and removing tool heads (fig. C)
Lock the tool by setting the forward/reverse slider (2) to
u
the centre position.
To remove a tool head, depress the head release button
u
(3) and take the head off the tool.
To fit a tool head, line it up with the tool as shown and
u
push it onto the tool until it snaps into place.
ENGLISH
7