Olsberg OEC II Instructions page 18

3
Screw on the door contact switch behind the com-
bustion chamber door on the right side.
First, push the connection cable through the instal-
lation opening.
Door contact switch
4
After the installation, check to make sure that the
door contact switch works perfectly when the com-
bustion chamber door is closed.
→ The combustion chamber door must close
perfectly.
→ The door contact switch must click audibly when
the door opens.
→ If necessary, adjust the depth of the door contact
switch.
18
5
Push the heating gas temperature sensor into the
sensor pocket on top of the heating jacket and screw
tight with the sensor sleeve and the union nut.
Heating gas temperature sensor
Union nut
6
Connect the sensor cable to the back or to the side
of the unit down to the wood storage compartment.
7
Push the cable of the power supply through the
grommet in the back panel at the bottom.
Sensor sleeve