Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING

To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
Caution
Use of controls or adjustments or performance of
procedures other than those specified herein
may result in hazardous radiation exposure.
The use of optical instruments with this product
will increase eye hazard.
This appliance is classified as a CLASS 1 LASER product under
IEC60825-1:2007.
2
FCC and IC notice
This equipment complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65 and RSS-102 of the IC radio frequency
(RF) Exposure rules. This equipment should be installed and
operated with at least 20 cm (8 in) and more between the
radiator and person's body (excluding extremities: hands,
wrists, feet and ankles).
This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
The wireless controller complies with FCC/IC radiation
exposure limits set forth for uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65 and RSS-102 of the IC radio frequency
(RF) Exposure rules. This equipment has very low levels of RF
energy that are deemed to comply without testing of specific
absorption rate (SAR).
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Cuh-1001a

Table des Matières