dji Ronin 2 Thumb Controller Guide De L'utilisateur page 5

2. Connect the USB-C port to the Ronin 2 14.4 V Accessory Power Port (located above the pan motor) using the
provided cable.
14.4 V Accessory Power Port
Calibration
The Thumb Controller is calibrated by default. Additional calibration is only required if the gimbal
drifts once connected to the Thumb Controller, such as if the gimbal moves by itself without input
from the thumb controller.
To calibrate the Thumb Controller, press and hold the two operating-mode buttons simultaneously:
The mid-point is calibrating when LED 1 is blinking. Do not operate the Thumb Controller during the
calibration.
The joystick is calibrating when LED 2 is blinking. During calibration, push and pull the joystick as far
as it will go in all directions.
The roll knob is calibrating when LED 3 is blinking. During calibration, turn the roll knob as far as it
will go in both directions several times.
Calibration is complete when the three LEDs blink simultaneously.
Using with DJI Force Pro
Connect the Thumb Controller to DJI Force Pro's DC OUT port using the provided cable.
DJI Force Pro's DC OUT Port
4