Applying The Cuff; Measurement Procedures - FLAEM NUOVA AD701K Mode D'emploi

10. Applying the cuff

1. Plug in the cuff connecting tube into the unit.
2. Unwrap the arm cuff, leaving the "Index" end of the
cuff through the D-ring of the cuff
3. Put your left arm through the cuff loop. The "OK"
range indication should be positioned closer to
yourself with the rubber tube pointing in the direction
of your arm. Position the artery mark ( ) over the
main arteries (on the inside of your
arm) in the upper arm.
4. Turn your left palm upward and place the
edge of the arm cuff at approximately 1.5 to
2.5 cm above the inner side of the elbow
joint. Tighten the cuff by pulling the "Index"
end of the cuff.
5. If the Index line falls within the OK range,
indicated at the edge of the cuff, this cuff
is suitable for your use. If the Index line
falls out of the OK range, you may need a
cuff with other circumferences.

11. Measurement Procedures

1. Press the User-Switching key to select Memory Zone 1 or Memory Zone 2.
To confirm your choice, now switch off the appliance by pressing
the START / STOP key. At this point, the subsequent
measurement will be automatically stored in the selected
channel.
2. To start measuring, press key START / STOP. All digits will light
up, checking the display functions. The checking procedure will
be completed after about 2 seconds.
3. After all symbols appear, the display will show a blinking "0". The
monitor is "Ready to Measure" and will automatically inflate the
cuff slowly to start measurement.
4. When the measurement is completed, the cuff will exhaust the inside
pressure. Systolic pressure, diastolic pressure and pulse will be
shown simultaneously on the LCD screen. The measurement is then
automatically stored into the pre-designated memory zone.
15
OR
Main
Artery
START
STOP
MON D
Main
Artery
Pulse
MON D
MON D
MON D
SYS
mmHg
kPa
DIA
mmHg
Pul.
min.