Sanus MF209 Mode D'emploi page 8

2
Wall Mounting - Wood Stud
For assitance in determining wall plate location, see Height Finder at sanus.com.
2-1
Locate stud
≤ 16 mm
(5/8 in.)
2-2
Level wall plate [02] and mark hole locations
2-3
Drill pilot holes as illustrated
2-4
Tighten lag bolts [23] only until the washers [24] are pulled firmly against the wall plate [02]
[24]
[23]
8
Verify the center of the stud using an awl, a thin nail, or an edge to edge stud
finder.


TV will shift 15 cm (6 in.) to the right or left when in the home position.
Consider this when selecting the location of your wall mount.
[02]
bolt. To avoid potential injuries or property damage: pilot holes MUST be
drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill
bit.
75 mm
3 in.
bolt. To avoid potential injuries or property damage DO NOT over-tighten
the lag bolts [23].
Fit lag bolt covers [26] over lag bolts [23].
[02]
[24]
CAUTION:
Avoid potential personal injuries and property damage!
Drywall covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.) nominal 38 x
89 mm (11/2 x 31/2 in.)
NOTE:
The MF209 is shown.
NOTE: For the MF209 only:
CAUTION:
Improper use could reduce the holding power of the lag
CAUTION:
Improper use could reduce the holding power of the lag
NOTE: The MF209 is shown.
[23]
[26]
13mm 5.5mm
(1/2 in.) (7/32 in.)