Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
SETTINGS
After fixing the detector and connecting the cables, please wait about 30 seconds before starting to
program it.
ADJUSTMENT OF THE COVERING AREA:
•
Set the "TIME" button to the "-" to make the operating time as short as possible (6 seconds)
•
Use the "METER" button to adjust the UNIDETECT's detection zone
-
-
ADJUSTMENT OF THE OPERATING TIME:
•
The "TIME" button allows you to adjust the operating time of the lights (between 6 seconds and
12 minutes)
-
-
SENSITIVITY ADJUSTMENT :
•
The "LUX" button allows you to control the operation of the device according to the ambient light
conditions.
-
-
12/22
by turning the knob towards the" -" the detection field is reduced.
by turning the knob towards the "+" the detection field increases.
by turning the knob towards the" -" you reduce the operating time of the device
(min. 6 seconds)
by turning the knob towards the "+" you increase the operating time of the device
(max. 12 minutes)
by turning the knob towards "
and night)
by turning the knob towards"
at dusk or only at night.
To set the
To set
desired
ambient
detection
light level
range
" UNIDETECT will operate continuously (day
" the UNIDETECT will operate when the light falls,
www.uniteck.fr
Manual
shut-off
of
timer control
Publicité
Table des Matières
