Samsung HT-H4500 Guide D'utilisation page 18

Settings
• Before you begin, confirm that the product is
connected to your router with a network cable.
K
Automatic
To start the configuration process, follow these steps:
1. In the Home menu, select Settings, and then
press the E button.
Select Network, and then press the E button.
2.
3. Select Wired Network Settings, and then press
the E button.
The Wired Network Settings screen appears.
Press the + button on the Internet Protocol
4.
Setup menu.
Use $% button to select Auto, and then press
the E button.
Settings
Wired Network Settings
Display
Audio
Internet Protocol Setup
Network
IP Address
System Subnet Mask
Gateway
Language
Security
DNS
General DNS Server
Support
5. The Network function acquires and fills in the
values for IP Address, Subnet Mask, etc.,
automatically.
6. After the Network function has acquired the
network values, press the
Select Network Test, and then press E . The
7.
home theater validates the network connection.
When it is done, press the
K
Manual
If you have a static IP address or the Automatic procedure
does not work, you'll need to set the Network Settings
values manually. You can get the Network Settings from
your Internet Service Provider (ISP).
: Auto
: 0 0 0 0
:
0 0 0 0
:
0 0 0 0
: Auto
:
0 0 0 0
> Move " Select ' Return
RETURN button.
RETURN button.
18
- English
Settings
Wired Network Settings
Display
Audio
Internet Protocol Setup
Network
IP Address
System Subnet Mask
Gateway
Language
Security
DNS
General DNS Server
Support
1. Follow the first four steps in the Automatic
procedure, but select Manual instead of Auto in
Step 4.
▼
2. Press the button to go to the first entry field (IP
Address).
3. Use the number buttons on your remote to enter
numbers.
4. When done with each field, use the ► button to
move successively to the next field.
You can also use the other arrow buttons to
move up, down, and back.
5. Enter the IP Address, Subnet Mask, and
Gateway values.
6. Press the ▼ button to go to DNS.
7. Press the ▼ button to go to the first DNS entry
field. Enter the numbers as above.
8. Press the RETURN button on your remote.
Select Network Test, and then press E .
9.
When the test is completed, press the
button to exit to the previous screen.
10. Select Network Status, and then press E .
11. The Network Status screen appears.
The product verifies the network connection and
then connects to the network. When it is done,
highlight OK, and then press E .
: Manual
0 0 0 0
:
:
255 255 255 0
:
0 0 0 0
: Manual
:
0 0 0 0
> Move " Select ' Return
RETURN