TechniSat DIGIDISH 33 Instructions De Montage page 9

1 Assembling the external unit
The external unit is delivered partially pre-assembled. Only the dish (Item 2) and the
connector rod (Item 3) need to be attached.
First, use bolts (A) to attach the dish to the AZ/EL bracket (Item 1). Then loosen screw (B)
on the swivel mount to attach the connector rod. After this, install the LNB (Item 5) on the
LNB bracket using the LNB clamp (Item 6) as shown in Figure 1.
2 Installation
Selecting a location
a)
Make sure that there is an uninterrupted line of sight from the location in which you
are planning to install the dish to the southern sky to enable reception from the positi-
on of the ASTRA 19.2° East satellite. You can use the illustration below to verify
whether you have left sufficient distance from any nearby obstruction to prevent the
obstruction from weakening signal reception. Make sure when installing beneath a
terrace that the dish is not within the shadow of any protruding roof.
b) Mount the wall bracket (Item 4) horizontally in the location selected.
In order to ensure that the external unit is as securely mounted as
possible, you should select the appropriate mounting hardware (scr-
ews wall plugs, etc.) for the surface onto which the unit is being
installed. Because of the wide variety of wall types, no wall bracket
mounting hardware is included.
c)
Loosen screw (C) on the wall bracket and attach the external unit using the connec-
tor rod.
Angle A Gradient B
(Elevation) (cm per m)
22°
24°
26°
28°
29°
30°
31°
32°
33°
34°
35°
36°
37°
38°
40.40
44.52
48.77
53.17
55.40
57.74
60.00
62.49
64.90
67.45
70.02
72.65
75.36
78.13
9