Uzin Utz WOLFF NEO 400 Mode D'emploi Original page 21

Observe the relevant regulations in your country for
the materials to be worked.
The vacuum cleaner must be approved for
the extraction of masonry dust. WOLFF provides:
Cleaner T-Rex #13314
Insert the suction hose of the vacuum
cleaner in the adapter (10) of the machine.
4.0 Operation
Starting Operation
► Observe correct mains voltage! The voltage of
the power source must match the voltage
specified on the type plate of the machine.
4.1 Handle height adjuster (I)
►The handle height adjuster (16) may be used to
set a comfortable working height.
By pressing the button (16), the height/angle of
the handle may be adjusted.
4.2 Grip height adjuster
► Loosen the allen bolts (13) with the supplied
allen key (20) to adjust the grip.
Bodenschleifmaschine NEO 400, #76970
08/2015
4.3 Switching On / Off - application (G)
1. Move the handle to the working position via the
handle height adjuster (16). (I)
2. Lift the machine by applying light pressure to the
handle to allow the motor to start up without load
3. Turn the switch (15) to the right, the motor starts up
W
► Check the direction of rotation of the
motor (J). Switch the phases in the plug, if
required. The fan wheel must rotate in an
anticlockwise direction.
4. Set the machine down carefully
5. Switch off by turning the switch to the left
► The machine can be stopped immediately
with the emergency stop (14).
4.4 Power consumption (F)
The display (12) indicates the power
consumption. (amps)
3 LEDs illuminated green:
► Machine operational, no faults.
LED illuminated yellow:
► Machine in overload range
LED illuminated red:
►Machine shutdown imminent
►Overload protection triggered
4.5 Gauge widening (K)
►Gauge widening allows the wheel spacing to be
increased by a maximum of 100 mm.
When working with additional weights, the wheel
spacing can be increased to allow more stable
machine movement.
21