Light Sensor; Explanations - Becker TC52 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Note
A light sensor can be connected to the device. See operating instruc-
tions for the Centronic SensorControl SC43 .
Selecting roller shutter
When the roller shutter function is used, the roller shutter remains locked after a
control button has been activated.
Selecting venetian blind
When the venetian blind function is being used, the venetian blind moves in
non¬maintained command mode in order to allow the slats to be positioned
more precisely. If you press and hold a control button for longer than 1 second,
the venetian blind will remain locked.
After the programmed intermediate position respectively lower final position has
been reached, the slats will be automatically adjusted (provided the reverse po-
sition has been programmed).
MAN/AUTO sliding switch
In the " " sliding switch setting, only manual command controls are carried out
(e.g.: UP, STOP, DOWN by pressing the relevant buttons).
In the " " sliding switch setting, automatic command controls are carried out
(e.g. shade function, twilight function, time, astro function,...)
Alarm signal control light
When the alarm signal control light is illuminated, this indicates an alarm signal.
If there is a permanent switching signal at the group or individual control inputs
for more than 5 seconds, it is an alarm signal.
Group control
Group control is control of several drives at the same time.
Operating mode
You will see the time and the current operating mode e.g. HOLIDAY in the display.
OK button
When the OK button is pressed, the currently displayed values are saved.
42

Light sensor

Explanations