Safety First; Safety Issues; Important - Enerpac FSM-8 Instructions

1.0 RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If
shipping damage is found notify carrier at once. The
carrier is responsible for all repair and replacement
costs resulting from damage in shipment.

SAFETY FIRST

Read all instructions, warnings and cautions
carefully. Follow all safety precautions to avoid
personal injury or property damage during system
operation. Enerpac cannot be responsible for
damage or injury resulting from unsafe product use,
lack of maintenance or incorrect product and/or
system operation. Contact Enerpac when in doubt as
to the safety precautions and applications. To protect
your warranty, use only Enerpac hydraulic oil.
A CAUTION is used to indicate correct operating or
maintenance procedures and practices to prevent
damage to, or destruction of equipment or other
property.
A WARNING indicates a potential danger that
requires correct procedures or practices to avoid
personal injury.

2.0 SAFETY ISSUES

Failure to comply with the following
cautions and warnings could cause
equipment damage and personal injury.
IMPORTANT: Minimum
operator must be 18 years. The operator
must have read and understood all
instructions, safety issues, cautions and
warnings before starting to operate the Enerpac
equipment. The operator is responsible for this
activity towards other persons.
WARNING: To avoid personal injury and
possible equipment damage, make sure all
hydraulic components
maximum pressure of 700 bar [10,000 psi].

IMPORTANT:

Minimize
overloading. Use hydraulic gauges in each
hydraulic system to indicate safe operating
loads. It is your window to what is
happening in the system.
WARNING: Do not overload equipment.
Overloading causes equipment failure and
possible personal injury.
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
enquiries@hyquip.co.uk
www.hyquip.co.uk/web/index
CAUTION: Make sure that all system
components are protected from external
sources of damage, such as excessive
heat, flame, moving machine parts, sharp
edges and corrosive chemicals.
CAUTION: Avoid sharp bends and kinks
that will cause severe back-up pressure in
hoses. Bends and kinks lead to premature
hose failure.
WARNING: Immediately replace worn or
damaged parts with genuine Enerpac
parts. Enerpac parts are designed to fit
properly and withstand rated loads.
WARNING: Always wear safety glasses.
The operator must take precaution against
injury due to failure of the tool or workpiece
DANGER: Do not handle pressurized
hoses. Escaping oil under pressure can
penetrate the skin, causing serious
injury. If oil is injected under the skin, see a doctor
immediately.
WARNING: Never pressurize uncoupled
couplers. Only use hydraulic equipment in
a coupled system.
IMPORTANT: DO not lift hydraulic
equipment by the hoses or couplers. Use
the carrying handle or other means of safe
transport.
age of the
WARNING: Never place fingers in a joint
held by activated wedge unless a safety
block is located into the joint.
CAUTION: The handle of the wedge is
there to stop operators holding spread
plates as the wedge is retracted. This will
stop fingers becoming jammed between plates.
withstand the CAUTION: Never hammer or force wedge
to access gap.
the risk of CAUTION: Don't operate the equipment
without lubricating the wedge and the 4
slide pins. Use high quality grease.
2