Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Installation
Operation
Caution
Trouble Shooting Aurora Paper Shredders
Maintenance
Limited Warranty
Manuel de fonctionnement
Installation
Fonctionnement
Avertissement
Dépannage des déchiquteuses
à papier Aurora
Entretien
Garantie limitée
Instrucciones para operar
Instalaciones
Operación
Avertencia
Solucionar Problemas de la Máquina
Trituradora de Documentos Aurora
Mantenimiento
Garantía Limitada
Please read these operating instructions before using the unit.
Customer Service: 1 - 800 - 327 - 8508 or INFO@AURORACORP.COM
Avant d'utiliser cet appareil, Veuillez lire toutes les instructions.
Service à la clientèle : 1 - 800 - 327 - 8508 OU INFO@AURORACORP.COM
Antes de operar esta unida, por favor lea todas las instrucciones.
Servicio al Consumidor: 1 - 800 - 327 - 8508 O INFO@AURORACORP.COM
1
15 sheets of
Sheet Capacity
20lb. bond paper
Credit Card & CD Capacity
1 at a time
5/32" x 1 9/50" pieces
Paper Shred Size
0.4 cm x 3.0 cm pieces
Voltage
120V-60Hz 4.0A
Capacité de passage
15 feuilles de papier
à la fois
bond de 75g/m2 (20lb.)
Capacité de CD et
les introduire un par un
les cartes de crédit
en morceaux de 5/32" x 1 9/50"
Dimensions des déchets
en morceaux de 0.4 cm x 3.0 cm
Tension
120V-60Hz 4.0A
Capacidad de
15 hojas de papel de
destruccióna la vez
cartes de 20 libras
Capacidad de CDs y
introdúzcalos en la ranura
tarjetas de crédito
uno por uno
en pedazos de 5/32" x 1 9/50"
Tomaño de corte
en pedazos de 0.4 cm x 3.0 cm
Voltaje
120V-60Hz 4.0A
( U.S.A. ONLY )
( ETATS-UNIS SEULEMENT )
( LOS ESTADOS UNIDOS SÓLO )
INSTALLATION :
Carefully unpack the shredder and connect the power cord to any standard 120 volt AC outlet.
Make sure the basket door is securely closed shut. Shredders with pull-out wastebaskets features a
safety power cut off upon bin removal. (FIGURE 1)
Caution: Crosscut shredders have very sharp, exposed blades on the underside.
FIGURE 1
FIGURE 2
OPERATION :
Using the power button or switch, turn on the shredder. The green light will indicate if the shredder is
powered on.
I
Auto: This setting allows the shredder to be automatically started by inserting paper into the
shred opening. Always feed the paper in as straight as possible. When the paper has
passed through, the shredder will stop. (FIGURE 2)
O
Off: This setting turns off all features of the shredder. For safety reasons, we recommend that
you leave the shredder in the Off position whenever the shredder is unattended or not
in use. (FIGURE 2)
REV: In the unlikely event of a paper jam, the reverse setting can be used to help clear the
cutters of paper that has not passed through. Never attempt to clear a jam by using
the reverse function until you have emptied the wastebasket. (FIGURE 3)
FW: The forward setting can also be used to help clear the cutters in the event of a paper jam.
This allows to manually activate the shredder into cutting mode. (FIGURE 3)
Caution: Never shred a credit card or CD/DVD by feeding through the paper feed slot. Never feed
more than one credit card or CD/DVD at a time.
Never shred plastic (except credit cards and only by inserting them, one at a time, through the special
credit card slot), continuous forms, anything with adhesive including labels and envelopes, newsprint,
or any hard materials. While this shredder will shred staples, it is recommended that you remove them
whenever possible in order to extend the life of your shredder.
FIGURE 3
2
Continued on next page
Publicité
