Troubleshooting Chart - Bakers Pride Y600 Série Manuel D'opération

CLEANING AND MAINTENANCE

Troubleshooting Chart

PROBLEM
No Pilot Light
Main Burner(s) do not light
Oven too Hot
Bottom of pies are undercooked If the same area of the deck is used repeatedly,
Bottom of pies burn before
toppings are cooked
Pies cook Unevenly
Oven does not turn On or Off on
time. (Ovens equipped w/auto oven
starter only)
Unit takes too long to reach temp. Gas volume or gas pressure may be inadequate. Contact gas supplier.
FLOOR MODEL GAS DECK OVEN OPERATION MANUAL
PROBABLE CAUSE
Gas valve feeding oven may be in the closed
position
Gas valve feeding oven may be in the closed
position
Thermopile may not be positioned in pilot flame. Ensure that the tip of thermopile is in pilot flame.
Thermopile may be defective
Thermostat set too high.
Thermostat may be defective
the deck temperature in that area will be reduced.
Micro slides are open too much.
Deck temperature too hot - especially during slow
periods.
Micro slides are closed too much
Oven was left "ON" overnight
Exhaust fan too powerful.
Area's adjacent to oven walls are generally hotter. Rotate pies (180°), once during each bake or keep
Power cord not plugged in.
Electrical outlet fuse/circuit breaker is tripped. Replace fuse or reset circuit breaker.
Timer incorrectly set.
Turn gas valve on. Relight pilot.
Turn gas valve on. Relight pilot.
Call local authorized Bakers Pride Service Agent.
Lower the thermostat setting and see if flame
reduces in size. Allow several hours for heat to
regulate.
Call local authorized Bakers Pride Service Agent.
Rotate pies to unused areas of the bake deck that
are hotter and will cook the bottoms faster.
Close micro-slides (pull out) until desired
combination is reached. This will help decrease
top heat
Reduce thermostat setting by 50° - 75° below
normal bake temperature. When decks cool begin
cooking and immediately increase the thermostat
setting by 50° - 75°.
Open micro slides (push-in) to increase top heat.
Oven must be turned to "Pilot" position overnight.
It should not be left on a high temperature setting.
Reduce fan speed.
to the center of oven.
Plug unit in.
Reset Timer.
Call local authorized Bakers Pride Service Agent.
11
REMEDY