Description Of The Device; Installation; Use - Far Rt2015 Manuel D'utilisation

ENGLISH

DESCRIPTION OF THE DEVICE

2
1
Glass shelf
1.
Temperature knob, lamp
2.
Plastic pallet
3.
Crisper
4.
Leveler leg
5.
NOTE: The appliance design is subject to change without prior notice.

INSTALLATION

Position the appliance and allow it to stand for two to three hours before it is turned
on for the first time to allow the system to settle. Do not position next to any heat
source e.g. cooker, boiler or in direct sunlight etc.
Allow at least 10cm of space at the top and 10 cm of space on both sides of the
appliance and between the back of the appliance and the wall for adequate air
circulation. The appliance is not designed for recessed installation ("building in").
Install on a good firm level surface, and any unevenness of the floor should be corrected
prior to installation, slight unevenness can be overcome by adjusting the front feet.
GB-6
3
4
5
NOTE:
If the appliance is positioned on a carpet, soft floor covering you should readjust the
front feet once the appliance has had time to settle.
In order to prevent the device from being tilted, the door bracket must be placed on a
flat surface, such as a floor, table, etc.

USE

• This appliance is designed to operate in ambient temperature between 16°C and
38°C. If these temperatures are exceeded, i.e. colder or warmer, the appliance will
not operate correctly.
• Remove all packaging materials from the appliance. Wash the inside of the cabinet
with lukewarm water and bicarbonate of soda (5ml to 0.5 liter of water). Dry the
appliance thoroughly.
• When you use the fridge for the first time or after defrosting, set the thermostat
control to the maximum position for at least 2 hours before introducing food to be
stored, and then readjust to the normal position.
• If there is a power failure, do not open the door. Frozen food should not be affected
if the failure lasts for less than 12 hours. If the failure is longer, then the food
should be checked and either eaten immediately or cooked and then re-frozen.
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat knob located inside the fridge,
towards the upper right-hand corner. Turn the knob from the STOP (OFF) position
towards the higher numbers for colder temperatures. The knob can be adjusted from
setting Min to Max.
Higher settings on the knob (max) mean lower temperatures (colder) in all
compartments of the appliance.
ENGLISH
GB-7