D-Link DWA-130 Manuel De L'utilisateur page 14

Section 2 - Installation
Push Button Configuration (PBC)
To connect to your network using the WPS push button
configuration method, click the virtual button as shown in the
screenshot.
Note: You may also connect to your network by pressing the
WPS button on the adaper and holding for two seconds until the
wizard screen comes up. Then, press the WPS button on the
router/access point to continue.
Press the WPS button on your access point or wireless router
within 2 minutes to establish connectivity.
When this screen appears, you have successfully connected to
your wireless network. Click Next to complete your setup.
Click Next
D-Link DWA-130 User Manual 14