Transport And Storage - FITFIU BEST-320 Manuel D'instructions

• The bike can be cleaned with a damp cloth and a mild non-abrasive detergent. Do not use solvents, sprays,
aerosols or pumps because they will leave wax residues on the surface of the screen.
• From time to time, the surface of the screen will have finger marks or dust on it. The use of harsh chemicals will
damage your protective coating and create static energy that will damage the components. This surface should
be cleaned with special chemicals that are sold in computer shops and which are special for anti-static surfaces.
We recommend the use of these products.
• Keep your bike, especially the console screen, out of direct sunlight to avoid damage.
• The safety of the equipment is maintained if its condition, damage and wear are regularly checked.
•
The bicycle must be moved and shifted carefully to avoid injury.
• The brake part is the one that wears out most easily. Before using the bike, check that the brake system is
working properly.
•
Check that the fastening elements are tightened properly.
• Carefully inspect the parts most susceptible to wear.
• Replace the defective parts immediately.
•
Keep the device out of service until it is repaired.
• Please check that all safety labels are in good condition and can be read. If any are missing or damaged, contact
your dealer to order new ones.
TROUBLESHOOTING
Problem
Pedal resistance.
The Control Panel doesn't work
NOTE: This exercise bike has been designed with safety as a primary concern. If after checking
the settings and the device, you cannot use the product, call FITFIU Technical Service.

TRANSPORT AND STORAGE

TRANSPORT
Stand in front of the bike and tilt it towards you to transport the equipment through the wheels
on its base.
STORAGE
To fold the bike, set the height of the saddle to the minimum, then remove the locking knob,
fold the bike as shown and lock it in the position indicated.
Store the equipment in a clean and dry interior. Never leave or use the unit outdoors.
Cause
The tension control knob is too high.
It's not on.
52
Solution
Reduce the tension by turning the
tension control knob in a clockwise
direction.
Check the batteries are correctly
installed, and that the cables are
properly connected and in good
condition.