Checking Of Press Fittings; Profile B (Ksp 1); Profile Th (Ksp 11); Profile F (Ksp 2) - emmeti Gerpex Manuel D'utilisation

4. CHECKING OF PRESS FITTINGS

Verification of the pressure fittings can be performed
by using a centesimal calliper to measure the pressed
fitting.
For a correct pressing, the detected dimensions (mm)
shall respect the chart.
If the dimensions don't match, the jaw could have not
closed completely or got worn.
Check that the pressing surfaces are clan and their
opening/closing is regular.
If the pressing continue to be non-compliant, is nec-
essary to control the machine by the service centre
indicated in the instructions.

4.1 Profile B (KSP 1)

Size
A max
Ø 14 14,55
Ø 16 16,60
Ø 18 18,60
Ø 20 20,65
Ø 26 26,60
Ø 32 32,65

4.2 Profile TH (KSP 11)

Size
A max
Ø 40 40,80
Ø 50 51,00
Ø 63 63,80
Ø 75 75,10
Ø Ø
B max
15,75
17,80
19,80
21,85
27,90
33,90
Ø Ø
B max
41,70
51,70
64,70
76,65
- Matrix Ø40, Ø50, Ø63 for jaw UW63
and single jaw Ø50, Ø63 and Ø75
NOTE: In case of pressing with Ø40 matrix, the hydrau-
lic seal is assured by the first two pressing profiles
next to the plastic ring of the fitting.
- Single jaw Ø40

4.3 Profile F (KSP 2)

Size
A max
Ø 40 40,65
Ø 50 50,80
Ø 63 63,70
Ø 75 74,10
Ø Ø
B max
41,90
51,90
64,90
76,50
GB
23