Concise Operating Instructions - Stecom TOPLINE Mode D'emploi

For indoor use only.
Several systems can be operated mutually without one system interfering with the other. No
manual settings are required due to controlling micro-processors in all system components.
STECOM is a registered trademark of CM Elektronik GmbH

Concise operating instructions

o Arming the system:
Press the blue "alarm" button on the control unit. The red "active"LED flashes. The
system is armed after 2 minutes.
o Disarming the system:
Press the blue "alarm" button on the control unit.
The red "active" extinguishes.
o Disarming the system once an alarm has triggered:
Press the blue "alarm" button on the control unit. The flashing red "active" LED extinguishes.
The alarm switch (option) and the siren (option) switch off. Switching sockets remain switched
on.
o Switching the automatic switching device on and off:
Press the "automatic switching device" button on the control unit. The neighbouring green LED
illuminates. Every time it is dark, the automatic switching device comes in to operation (for 5
hours).
Press the "automatic switching device" button on the control unit again. The green LED
extinguishes, the automatic switching device is no longer in operation.
o Remote switching on/off of the switching sockets:
Press one of the buttons 1 to 4 on the control unit. The switching socket switches on after a
short delay. The corresponding green control LED on the control unit flashes.
Press one of the buttons 1 to 4 on the control unit once again. The switching socket
switches off after a short delay. The corresponding green control LED on the control unit is
constantly lit.
Overview of the indications on the control unit during normal operation
(system armed or disarmed)
LED's
OFF
ON
FLASHES
SLOWLY
FLASHES VERY
SLOWLY
FLASHES
FAST
English
Green LED for siren,
alarm switch, switching socket,
yellow LED for detectors
Components
not receiving/
not available
normal operation/
good reception
Motion detector active,
components active
(siren/alarm switch/switching socket).
Component available/
bad reception
Red LED "active"
System disarmed
System armed
System is armed
or triggered.
time delay is running
Alarm was triggered,
system is armed
System is activated
(after warn signal) or
alarm active
Seite 38