Philips Lumea Comfort SC1982 Mode D'emploi page 23

Problem
I have pressed
the on/off/inten-
sity button, but
the appliance
does not switch
on.
The appliance
does not emit
a flash when I
press the flash
button.
Possible Solution
cause
You have not Make sure that you insert the small plug into
plugged in the appliance socket properly. Check if you
the appliance have inserted the adapter into a live wall
properly. socket properly.
Your skin The READY/skin colour warning light blinks
colour is not rapidly. This indicates that the skin colour
suitable for sensor measured a skin colour that is too
treatment dark for safe treatment. You can try the
with this appliance on a different area where the
appliance. skin is lighter. If your dark skin colour is due
to recent sunbathing or tanning, wait for 2
weeks and then try again. If the dark skin
colour is your natural colour, please check
the table in chapter 'Preparing for use',
section 'Skin colour and light intensity' to see
if the appliance is suitable for you at all.
The READY/ Make sure that the skin contact surface is
skin colour in full contact with the skin. When it is, the
warning light READY/skin colour warning light starts blink-
continues ing slowly and you can press the flash button
to light up to release a flash.
steadily.
The READY/ The appliance has a system error. Switch
skin colour off the appliance, unplug it and then try to
warning switch it on again. If the problem persists,
light and the visit www.philips.com/support or contact the
intensity lights Philips Consumer Care Centre.
are all on.
ENGLISH
23