AGA marvel M18SZ Instructions D'installation, D'utilisation Et D'entretien page 19

CUSTOM GRILLE FACIA AND DOOR PANELS
68 ⁄ "
3
16
(173.2cm)
4 ⁄ "
5
16
(11cm)
Minimum typical
Figure 23
22 ⁄ "
11
32
(56.7cm)
Door Gasket-
Screw-
Glass door-
Door panel-
Step 2: Size the Overlay Panel
Cut the custom overlay panel to the dimensions shown in
Figure 23.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
19
Figure 24