AGA marvel M18SZ Instructions D'installation, D'utilisation Et D'entretien page 17

Mounting grille facia panel:
Cut the facia panel to the size shown in Figure 18. Drill the
two facia bracket screw pilot holes in the back side of the
facia panel as noted in Figure 18. See Table B, for sizes.
Fasten the two facia brackets to the back side of the facia
panel with 2 of the screws provided. See Figure 19.
Align the facia brackets so they are parallel to the short
edges of the facia panel and drill the remaining 2 bracket
holes using the holes in the facia brackets as guides.
Secure the bottom of the brackets with the 2 remaining
screws.
The facia panel may now be mounted to the grille back.
CAUTION
!
When cutting the facia panel for the grille do not make
it larger than the size noted in Figure 18. Air flow to the con-
denser in the power module would be compromised. Grille
facia panels must not exceed 20 pounds (9.1kg), panels
weighing more could cause product damage. Do NOT use
glass, mirrors, granite or similar heavy materials for panels.
CUSTOM GRILLE FACIA AND DOOR PANELS
2 ⁄ "
21
32
(6.8cm)
1 ⁄ "
1
8
(2.9cm)
MATERIAL HOLE SIZE
Hardwood ⁄ " (3.2mm)
1
8
Softwood ⁄ " (2.8mm)
7
64
Table B
Facia panel-
Screw 2
required-
Drill bottom 2 holes
for mounting brack-
ets and secure with
remaining 2 screws.-
17
21"
(53.3cm)
15 ⁄ "
11
16
(39.8cm)
Figure 18
Drill 2 holes, see Table B.
-Facia bracket
Figure 19
8 ⁄ "
3
4
(22.2cm)