Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
> Before Start
> Part Names
Connect the Speakers
Install
1
2
a Speaker cable
> Install
> Initial Setup
a
a
> Playback
3
Advanced Setup | Firmware Update | Others
Use the illustration as a reference to connect your own
speakers.
After inserting the speaker cables, tighten the terminals
firmly by turning to the right. Also make sure the exposed
wires of the speakers do not stick out of the speaker
terminals when connecting. If the exposed wires of the
speakers touch the rear panel or the i and s wires touch
each other, the protection circuit may be activated and the
power may turn off.
You can also connect a subwoofer with a built-in amplifier to
boost bass playback even more. Use a subwoofer cable for
connection.
E
N
7
Publicité
Chapitres
Table des Matières
Dépannage
