Honda Power Products F720 Manuel De L'utilisateur page 28

7. P.T.O. (Power Take Off) operation
The P.T.O. shaft is used for stationary work, hulling, spraying and
moving, etc.
To use, remove the three 6 mm bolts and P.T.O. cover.
To use, remove the P.T.O. cover.
When using for stationary work, the gear shift lever should be
shifed into Neutral position.
Do not operate the tiller without the P.T.O. cover when the P.T.O. is
not used.
8. A.C. output
An alternating current (12V 50W) can be taken out of these terminals.
P.T.O. SHAFT
(GE Type)
−
6 mm BOLT
P.T.O. COVER
27