Adjusting The Clutch; Lever Control Box Mounting - Ultraflex B 301 Manuel D'installation Et D'entretien

ULTRAFLEX

3.6 Adjusting the clutch

Both the control boxes B301 and B302 allow the adjustment of the clutch. Follow the instructions below
1 Rotate the lever in the middle throttle position;
2 Screw the dowel (18) to obtain the hardening of the clutch, or
unscrew it to obtain a smoother movement. To check the friction of
the lever, move it clockwise and counter clockwise. ADJUSTING THE
CLUTCH MUST BE PERFORMED WITH ENGINE TURNED OFF AND THE
LEVER IN THROTTLE POSITION.
WARNING
DOING THIS SETTING IN GEAR POSITION CAN DAMAGE THE SYSTEM.
3 CONTROL B301:
Place the rear cover
(4) fixing it with the
screws (5).

3.7 Lever control box mounting

1 Put the control box
in the selected
position, then insert
and thighten the four
screws M5x35 (B),
with washers (D) and
nuts (C).
D
2 Place the sticker supplied on the chromium plated covering.
page 12
of 47 -
SINGLE LEVER CONTROL B301 AND B302
4
2
B 301
5
C
B 301
Installation and maintenance manual
CONTROL B302:
5
Connect the two
boxes (6) with the
screws (5).
B
D
C
6
5
B 302
B
B 302
:
18
6
5