Gardner Bender WIC-100 Manuel D'utilisation page 3

5. To view the camera's point of view, open the Gardner Bender Wifi Camera application on your device.
NOTE:
Camera is on and working properly when green LED is visible on camera handle. If the LED turns red, the
battery voltage is low and the batteries need to be replaced.
If you forget the SSID and password for the camera, you can reset the camera by pressing the RESET button
located just above the Power Indicator LED.
If you are having issues with your device finding the wifi signal from the camera, try turning wifi off on your
device, turn on the camera, then turn wifi on again in your device. This should refresh the list of available
networks in your area.
Installation of App- iOS
™
To install the Gardner Bender Wifi Camera software on your Apple iOS™ device you will
need to do the following:
1. Open the App Store application and search for "Gardner Bender."
™
App Icon
2. Select the Gardner Bender Wifi Tool application.
3. Press INSTALL. The software should begin to download to your device.
4. After the installation is complete, the Wifi Tool icon will appear on your home screen.
Wifi Connection- iOS
™
1. Open the Settings app on your device and select the WIFI category.
2. Select WIFICAMERA from the list of available wifi networks.
3. Connect to the network with the default password 88888888.
NOTE: If the connection between the device and camera is lost, turn the camera off and then back on to
reset the connection. Repeat Wifi Connection process.
If the device and camera successfully connect, when you open the Wifi Tool app, the image seen by the
camera should be displayed on your device. If there is a problem with the Wifi connection, the screen will
look like the screen below:
www.gardnerbender.com | N85 W12545 Westbrook Crossing | 800.624.4320 | tech.support@gardnerbender.com