Connecting The Ac Adapter - Epson OT-SC20 Manuel D'utilisation

Press this button to remove the printer.
2 Charge LED
Lights when charging is proceeding normally. (
Lights/Flashes when an abnormality occurs. (
3 Charge Terminal
For connecting the printer and battery.
4 DC-in Connector
For connecting the AC adapter. (

Connecting the AC adapter

Follow the procedure below to connect the AC adapter to the single charger. See
illustration B on page 4.
1. Insert the DC connector of the AC adapter into the DC-in connector on the single
charger securely to the bottom.
2. Insert the AC cable connector into the AC inlet of the AC adapter securely to the
bottom.
3. Fully insert the power plug securely into the grounded outlet.
4. Set the label side of the AC adapter facing down.
Charging the Printer
Charge the printer by following the steps below. See illustration C on page 4.
!
CAUTION:
❏
Charge the printer at an ambient temperature between 10 and 30°C {50 and 86°F}.
❏
Make sure there is no foreign matter or grease, etc., adhering to the charging terminal.
1. Set the printer in the single charger. Push down the printer until it clicks.
2. Charging starts and the Charge LED turns on.
3. When charging is complete, the Charge LED turns off. Press the Release button and
remove the printer.
Cleaning the Single Charger
Before cleaning the single charger, unplug its AC cable from the outlet, without fail, and
wipe off dirt with a dry or slightly wet cloth.
!
CAUTION:
Do not use solvents such as alcohol, benzine, or paint thinner. Using such solvents may
transform or damage the plastic or rubber parts.
U "Charge LED does not turn on" on page 8
U "Charge LED is flashing" on page 8
U "Connecting the AC adapter" on page 7
)
)
)
7