Variable Speed Trigger Operation; Forward/Reverse Switch Operation; Hammering/Drilling Switching Lever - Textron Greenlee LRH-144 Manuel D'instructions

Operation—Power Tool (cont'd)

Variable Speed Trigger Operation

1. The speed increases with the amount of depres-
sion of the trigger.
When beginning work, depress the trigger slightly
to start the rotation slowly.
2. A feedback electronic controller is used to give a
strong torque even in low speed.
3. The brake operates when the trigger is released
and the motor stops immediately.
Note: When the brake operates, a braking sound may
be heard. This is normal.

Forward/Reverse Switch Operation

• If the bit becomes jammed, immediately release
the trigger to prevent an overload which can
damage the battery pack or motor. Use reverse
motion to loosen jammed bits.
• To prevent damage, do not operate Forward/
Reverse switch until the bit comes to a complete
stop.
• Do NOT operate the Forward/Reverse switch
when the trigger switch is on. The battery will dis-
charge rapidly and damage to the unit may occur.
Forward
Switch lock
Forward Rotation Switch Operation
1. Push the switch for forward (clockwise) rotation.
2. Depress the trigger slightly to start the tool slowly.
3. The speed increases with the amount of depres-
4. After use, set the switch to its center position
Reverse Rotation Switch Operation
1. Push the switch for reverse (counterclockwise)
2. Depress the trigger slightly to start the tool slowly.
3. After use, set the switch to its center position
Switch Lock Operation
Push the switch to its centered position to lock the
tool. In the switch lock position, the trigger will not be
able to be depressed and the tool will not be allowed
to operate.

Hammering/Drilling Switching Lever

Note: Do not change modes until the motor rotation is
completely stopped.
Switching Lever
Reverse
11
sion of the trigger for efficient tightening of
screws and drilling. The brake operates and the
chuck stops immediately when the trigger is
released.
(switch lock).
rotation. Check the direction of rotation before
use.
(switch lock).
Position of
Action Mode
Rotation with
hammering
Rotation only
LRH-144
Operation
Concrete drilling,
block drilling
Screw fastening,
drilling