Wall Mount Installation - AEG Voxtel C100 Mode D'emploi

4
4 INSTALLATION
1. Locating the base unit (See P2 and P3)
The base unit should be placed on a level surface, in a position where:
the telephone line cable will reach your telephone line socket or extension socket.
it is not close to a sink, bath or shower, or anywhere else where it might get wet.
it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs,
fluorescent lights, etc.
2. Plug the coiled handset cord into the handset. Plug the other end into the socket on the side
of the base unit.
3. Place the handset on the base unit.
4. Plug the telephone line cord into the phone line socket at the back of the base unit and the
other end into your telephone line socket.
5. Lift the handset and check for dial tone in the earpiece.
5

WALL MOUNT INSTALLATION

To place the Voxtel C100 on a wall, connect the wall mount bracket to the bottom of the phone in the
slots near the front of the base as shown below.
Insert the rigid clips of the bracket into the slots on the bottom of the phone (nearer the front of the
base). Press down firmly until the flexible clips click into place in the slots nearer the centre of the
base. To remove the bracket, (1) pinch the flexible clips, (2) back the bracket, and then (3) slide up and
forward as shown below.