Hestan Cue KICS30 Manuel D'installation Et D'entretien page 22

SMART COOKING
PAIRING WITH THE COOKTOP PAIRING WITH THE COOKTOP
PREPARING FOR CONNECTION PREPARING FOR CONNECTION
EN
On your tablet or smartphone, install the Hestan Cue app. Have the Bluetooth mode, the Wi-Fi
mode and the location system activated.
PAIRING YOUR FIRST DEVICE PAIRING YOUR FIRST DEVICE
Launch the Hestan Cue app, create your account (unless you already have an account) and log in.
When the app is ready to connect to the cooktop, do the following:
Action
Activate the cooktop
Activate the Bluetooth detection
mode
Wait until the connection status indicator switches off before pairing any other devices.
• The connection needs to be done once for each tablet or phone you will use with the Hestan
Cue app.
PAIRING/CONNECTING ADDITIONAL DEVICES PAIRING/CONNECTING ADDITIONAL DEVICES
When you wish to pair an additional device, it must be prepared as above under PREPARING
FOR FOR CONNECTION CONNECTION. Start the Hestan Cue app and log in.
When the app is ready to connect, do the following:
Action
Activate the cooktop
Activate the Bluetooth extended
mode
Observe any further instructions from the app.
Once pairing is complete, you can control the Cue-enabled cooking zone with the Hestan Cue
app.
MAXIMUM NUMBER OF PAIRINGS MAXIMUM NUMBER OF PAIRINGS
The cooktop can have up to eight Bluetooth devices paired at once.
Note that this limit has nothing to do with the number of Cue-enabled devices or Smart
Cookware pieces you have. It is only the number of smartphones or tablets that can pair with
the cooktop itself.
When you pair an additional device, the oldest pairing will be removed.
COOKWARE CONNECTIONS COOKWARE CONNECTIONS
Follow the instructions that came with the cookware and prompts from the app to connect with
Hestan Cue cookware.
20
©2020 Hestan Commercial Corporation
(CONTINUED)
Control panel
Press Power key [ ]
Press [ ] (about 5seconds) until you
hear 2 beeps
Control panel
Press Power key [ ]
Press [ ] once
Display
[ 0 ]
The LED over [ ] is blinking
PREPARING
Display
[ 0 ]
The LED over [ ] is illuminated