Warranty - N-Com B601 R Serie Mode D'emploi

EN
16

WARRANTY

Certification and Safety Approvals - FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antennae
•
Increase the separation between the equipment and the receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance. The antenna used
for this transmitter must not transmit simultaneously with any other antenna or transmitter, except in
accordance with FCC multi-transmitter product procedures.
When equipped, the distance between antenna and one's head surface is 30.63mm. EUT is marketed without
helmet, so when the EUT is mounted with helmet, it has to be to maintain a distance of 30.63 mm from one's
headsurface.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the party responsible for
compliance could void user's authority to operate the equipment.
Industry Canada (IC) Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two
conditions: 1) this device may not cause interference and 2) this device must accept any interference, including
interference that may cause undesired operation of device.
This class B digital apparatus complies with Canadian ICES-003.
IC Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users
must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
When equipped, the distance between antenna and one's head surface is 30.63mm. EUT is marketed without
helmet, so when the EUT is mounted with helmet, it has to be to maintain a distance of 30.63 mm from one's
headsurface.
Model: B601 R
PMN: N-Com B601 R
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
22
FCC ID: IC:
Y6MNCOM18 9455A-NCOM18
R-NZ